Brake Caliper Adapter Golf Corrado Passat 2 G60 Porsche 996 Brake System Golf 4 R32 Brake discs 334×32

Brake caliper adapter on Golf MK2 G60 models for conversion to Porsche 996 brake caliper, combined with the Golf MK4 R32 brake discs, 334x32mm.

Suitable for the following vehicles with 4×100 hub PCD:

• Golf MK2
• Golf MK3
• Passat 35i
• Corrado

Advantages:

• high deceleration, also in conjunction with our rear axle braking system
• thanks to the material certificate supplied with the order, it is possible to register your purchase even for series vehicles
• directly fit to the above-mentioned models and therefore can always be restored to the original state without any problems
• our EPYTEC brake caliper adapters do not require any sending of your serial parts, no welding, milling or drilling

Required components:

• brake calipers: Porsche 996 turbo , reference left 996.351.429 + right 996.351.430
• brake discs: Golf 4 R32  334×32 mm , reference 1J0 615 301A and 1J0 615 302 A
• modification of the disc PCD to 4×100 (possibility of making it directly from EPYTEC)

Delivery:

• 2x brake caliper adapters
• high-strength mounting screws
• material certificate

Notes/tips:

For a better ventilation of the brake system, we recommend removing the dust cover plates and brake anchor plate.

For brake conversion on the rear axle, we recommend that you generally proceed as follows:

• install the adapter with the necessary components and then check if new brake lines are required. Because, depending on the vehicle, the lines may be too short or the line tips may not suitable. We advise you to change to steel braided brake line because of the quality and technical advantage. Specifically for this, we have developed an online brake line configurator, where you can assemble the type of steel braided brake lines you want. Click here to go to the configurator >> Stahlflex-Bremsleitung konfigurieren <<
• always use the hand brake cable of the installed brake caliper. So sometimes you have to modify / adapt the new handbrake cable. For conversions, where the original caliper is used and the handbrake cable can be used, you may need to pull the cable without any other fittings (ie directly) to compensate for the long distance due to the large diameter of the large brake discs.