Brake Caliper Adapter Audi A4 B6 Porsche 986 Boxter Brake Conversion A8 Brake Disc

303,40 €

* Price excl. VAT

2x brake caliper adapters
high-strength mounting screws
Stress analysis / FEM calculation for entry
material certificate

ETA: 6 - 8 weeks

SKU: E866 Category: Brake adapters brackets

Brake caliper adapter on Audi A4 B6 B7 series to convert to Porsche 986 brake caliper, combined with the original Audi A8 brake discs 312x25mm.

Suitable for the following vehicles:

Audi A4 B7
Audi A4 B6

Advantages:

high deceleration, also in conjunction with our rear axle braking system
thanks to the material certificate supplied with the order, it is possible to register your purchase even for series vehicles
directly fit to the above-mentioned models and therefore can always be restored to the original state without any problems
our EPYTEC brake caliper adapters do not require any sending of your serial parts, no welding, milling or drilling.

Required components:

brake caliper: Porsche Boxter 986, reference 986.351.421 + 986.351.422
brake disc: Audi A8 RS 312x25mm, reference 8E0 615 301 R

Tipps, Infos und Hinweise:

For better ventilation of the brake system, we recommend removing the anchor plates/brake dust plates.
For easy mounting of the rim, we recommend purchasing two of our wheel mounting aids at the same time >>go directly to the article here<<
We cannot give a general answer as to which rim size you can drive after your brake conversion. There are simply too many different rims. In rare cases, it can happen that the rims have minimal contact with the brake calliper, in which case you can simply use wheel spacers. >> Go directly to custom wheel spacers <<
Install the adapter with the required components and then check whether new brake lines are required, as the old ones may not be long enough or the connection may not fit, depending on the model. Due to the significantly better efficiency, we recommend switching to steel braided lines. We have developed a steel braided line configurator especially for this function, where you can assemble and then install them according to your requirements. Click here for the steel flex configurator >> Configure steel flex brake line <<

Please note that our articles have been designed for racing and motorsport. Use in public road traffic usually requires an individual approval in accordance with § 21 StVZO by an officially recognised expert. Further information can be found under TÜV Süd. For the individual approval, we will provide you with an expert opinion or material certificate, if available.