Audi S2 brake calliper adapter rear axle 302×12 brake disc brake system conversion

166,11 €

* Price excl. VAT

  • 2x brake calliper holder (see picture)
  • high-strength screw material
  • Material certificate

ETA:

SKU: E595 Category:

Brake caliper adapter to mount Audi A6 brake discs in 302x12mm on the rear axle of the Audi S2 Coupe (not suitable for Avant and Limo) and identical rear axles.
With our adapters, the original Audi S2 Coupe brake calipers on the rear axle can be retained. The brake caliper carriers must be minimally worked on with a file on the inside dimension where the disc runs (0.5-0.7mm)!

Required components:

A6 brake discs from all-wheel drive 302x12mm is the exact part number: 24.0112-0176.1 412176

Advantages of this braking system:

  • Extreme deceleration values ​​also in conjunction with our front axle braking system
  • The material certificate included in the scope of delivery enables registration by individual acceptance even for series vehicles
  • Directly suitable for the above-mentioned models and can therefore be easily restored to the original condition at any time

 

Our EPYTEC brake calliper adapters do not require you to send in your standard parts, nor do you need to re-weld, re-mill or re-drill.

We also offer a suitable brake system for the front axle. Take a look in our shop!

Scope of delivery:

  • 2x brake calliper holder (see picture)
  • high-strength screw material
  • Material certificate

Tips, information and hints:

  • For better ventilation of the brake system, we recommend removing the anchor plates/brake dust plates.
  • For easy mounting of the rim, we recommend   purchasing  two of our wheel mounting aids at the same time >>click here to go directly to the article<<
  • We cannot give a general answer as to which rim size you can use after your brake conversion. There are simply too many different rims. In rare cases, it can happen that the rims are only slightly in contact with the brake calliper, in which case wheel spacers can simply be used.>> Now directly to wheel spacers as desired <<
  • Install the adapter with the required components and then check whether new brake lines are required, as depending on the model, the old ones may not be long enough or the connection may not fit. We recommend switching to steel braided lines because they are much more efficient. We have developed a steel braided configurator specifically for this purpose, which you can use to put them together according to your requirements and then lay them out.Click here to go to the steel braided configurator >> Configure steel braided brake line <<
  • The handbrake cable must always be used from the installed caliper, which means that the new handbrake cable may need to be adjusted slightly. For conversions in which the original caliper is still used and the original handbrake cable can be used, you may have to route it in a more direct way to compensate for the larger disc diameter and the longer path

Reviews

There are no reviews yet.

Be the first to review “Audi S2 brake calliper adapter rear axle 302×12 brake disc brake system conversion”